35
EN
To increase the appliance's service life and optimise its operation, there is an automatic
bleed built into the upper part of the towel dryer radiator frame.
This operates completely autonomously, with no user operations required.
Automatic bleed
It is possible to reset the radiator, erasing all the settings made (programs, calibration,
maximum temperature, heating indicator). This function is particularly useful in case of
programming errors.
1 - Press and hold the
and
buttons at the same time for more than 3 seconds to
display
.
2 - Press three times to display
(Factory Settings).
3 - Press
,
will flash alternately with
.
4 - Press
to display
.
5 - Press
to confirm. All the indicators will light up. The radiator will then return to
manual mode at 19°C.
X3
> 3 s
FACTORY SETTINGS
There is an automatic inactivity timeout on the control panel display after a few seconds,
with the exception of the heating indicator, which is lit when the resistor power supply is on.
It is possible to configure the panel so that the indicator goes out when the panel display is
switched off.
1 - Press and hold the
and
buttons at the same time for more than 3 seconds to
display
.
2 - Press
twice to display
(Heating Indicator).
3 - Press
,
will flash alternately with
.
4 - Press
to display
.
5 - Press
to exit.
X2
> 3 s
HEATING STANDBY INDICATOR
Summary of Contents for TRI EG IC0
Page 44: ...40 U0702736 B Sept 22 ...
