42
Problem
Check
The surface of the
appliance
is hot.
When functioning, the appliance will be normally warm; the maxi-
mum surface temperature being limited in accordance with the
NF Electricity Performance standard. However, if you find that
your appliance is still too warm, make sure the power is adapted
to the size of your room (we recommend 100 W/m2 for a ceiling
height of 2.50 m or 40 W/m3) and the unit is not placed in an air
draught which would disrupt its functioning.
Traces of dirt appear
on the wall around
the appliance.
In polluted environments, dirt may appear on the air outlets of the
appliance or on the wall. This is associated with the poor quality
of the ambient air (cigarette smoke, candles, incense, fire place, ...).
In this case, the good ventilation of the room should be checked
(ventilation, incoming air, etc.).
The Expert Menu is
not accessible.
You saved a PIN. You must enter your PIN to access the Expert
menu (see the Expert Menu chapter).
If you forgot your PIN, enter the code 081.
The temperature is
blocked at 23° C
Access to the temperature setting is restricted. This access is
secured through a PIN by activating the Expert Menu.
The unit does not
follow internal
programming
commands.
Make sure the date and time are set.
Make sure the unit is in PROG mode and internal programming
has been selected.
The unit does not
follow external
programming
commands.
Make sure the programming unit is correctly used (see Program-
ming unit operating instructions).
Make sur the unit is in «Ext. control» programming source.
If you have not been able to solve your problem, contact your distributor/installer with the
reference numbers of the appliance. They are located on the side of the unit. Measure the
room temperature.
The Commercial Code (C) and Serial Number (E) will allow the manufacturer to identify
the appliance you purchased.
A
Standards, quality marks
B
Trademark
C
Commercial Code
D
Manufacturing reference
E
Serial No.
F
Manufacturer No.
6
A
B
C
D
E
F
(photo non contractuelle)
Summary of Contents for ACCESSIO DIGITAL 2
Page 3: ...2 ...
