Atlanta ATH-857, Instruction Manual

Page: 5 / 20

5
INSTRUCTION MANUAL
for lubrication. After lubrication, switch on the device to distribute the oil and then
remove surplus oil with a cloth.
It is necessary sometimes to remove blades to clean hair clipper well. Please
remember the position of blades to each other, as the lower blade is adjusting and
can be installed in different positions.
This model can be fitted with a screw adjustment of the blades. If the hair
clipper does not cut well, it is necessary to unscrew slightly counter-clockwise this
screw. If the hair clipper is too much noise, you need to tighten a little bit this screw
clockwise.
HAIR CLIPPER OPERATION
1. Check if the device requires lubrication. Charge the device completely.
2. Plug in the machine to the mains.
3. Remove the protective cover to the clipper blades. Please hold it to the handle,
do not touch the blades by hand all the time it is plugged.
4. If you need set one of the four nozzles, which allow to receive as a result of
cutting the hair of varying lengths.
The attachment is recommended to be set in the position enabling to leave the
longer hair; if required, the position for leaving the shorter hair can be set later.
5. Set the switch (C) into the forward position and start clipping. Change the
attachments only when the device is switched off.
6. If you need a length exceeding 12 mm, remove the attachment and use the
comb, or adjust the length with the fingers of your free hand.
7. Firstly, handle a small section of hair to get used to the length of the hair being
cut. Start to clip from the occipitals and at the sides, then clip in the front moving
to the crown; all the movements should be performed against the hair growth
direction.