Atlanta Attachment Company 1335MG, Technical Manual & Parts Lists

Page: 44 / 178

Manual & Parts Lists Technical
37
2.5.- Sewing Procedure
Please follow all safety procedures, turning off
power is recommended.
1) Start by pressing down on the right side of the
Foot Pedal. The sewing head will start feeding
both the border and the panel. The operator only
has to guide the panel. Do not hold back on the
panel; allow the panel tension to do its job.
2) The edge of the panel will move past the cut out
in the table for the End Sew Eye to read the
reflective tape. Once the eye “sees” the tape then
it activates the stop count (thumbwheels 3 and 4
together on the ruffler control box). The sewing
head will go into slow stitch speed, the sped of
which is set by thumbwheel 2.
3) Once the stop count has ended the ruffling
blade will drop and make the ruffles. The number
of ruffles is based on what thumbwheel 5 is set to,
in this example it is set to 7 for two ruffles in
square or straight sew mode. While the ruffle is
being pushed under the foot and sewn the machine
is counting the number of stitches set in
thumbwheel 6, once this count has been reached
the ruffling blade will retract. Once the
ruffle/ruffles are complete the sewing head will
sew two stitches and then stop. The number of
stitches sewn after the ruffle is set by thumbwheel
1, the count is double the number displayed. The Operator will keep the foot pedal pressed during this
whole cycle.
From
the
library
of:
Diamond
Needle
Corp