3. Plug the other end of the LAN cable into the network wall socket, switch or router. Note
If you have a PC already connected to the network port you wish to use, disconnect the PC
from this network port and reconnect it into the port marked “PC” on the IP 250.
4. Plug the mains adapter provided into a 240 Vac mains socket, and the 12Vdc power jack
into the socket located at the rear of the phone. Note If using POE please skip this step as
power will be provided to the phone via the LAN connection.
Note You will need a PC connected to the same network to configure your IP 250.
1. Allow the IP 250 to boot, once the phone is ready the date and time will be displayed
across the top of the screen.
2.1. DHCP NETWORK
Press the SET button and a menu should appear, now press 2. This will take you in the net-
work setup now press 1 three times. You should now see what is known as an IP address
and will appear in the format xxx.xxx.xxx.xxx, make a note of this. If there is no address
shown the network you are connected to is not using a DHCP server or the phone is not
correctly connected.
2.2. STATIC NETWORK
Connect the phone to a network with a DHCP Server to obtain an IP address. Once an IP
address has been obtained log into the phone via the web interface and configure it with a
static IP address. For more information please see the user manual.
3. Now that you have your IP address open up Internet Explorer on a computer that is
connected to the same network as the phone and in the address bar enter that IP address
that was obtained in step 2. A popup box asking for a username and password should now
be displayed. The default username and password are admin/voip
4. The homepage for the IP 250 should now be displayed. Click the SIP heading and then
enter the relevant details that you have obtained either from your network admin or your
ITSP into the address and port fields for the primary server and if you will be using an
outbound proxy then fill in this field as well. Click the Save SIP Settings button and reboot
the phone but pressing the reset button ensuring that Reset and execute Main Application
is selected.
5. Once the phone has rebooted log back into the phone (repeat step 3) and select the SIP
menu again. Now select User 1 from the menu and fill in the boxes for the primary server
using the details provided by your ITSP or network administrator. Now reboot your phone,
once again making sure Reset and execute Main Application is selected.
6. Your phone should now be ready to make calls. If your phone has successfully registered
your telephone number or CID name will appear on the phone below the date and time.
►
►
►
►
►
►
►
►
►
Making a call
Lift Handset
Dial a number on your sip network
1.
2.