Quick-Change
Installation and Operation Manual
Document #9620-20-H-UAx-13
Pinnacle Park
•
1031 Goodworth Drive
•
Apex, NC 27539
•
Tel: 919.772.0115
•
Fax: 919.772.8259
•
www.ati-ia.com
•
Email: [email protected]
H - 5
Figure 2.2—Master Module Swivel Installation
2.4 Master Module Swivel Removal
1.
Apply pressure to the swivel to compress the spring and remove the retaining ring from the back
. Note: If retaining ring is a snap type ring use snap ring pliers to
remove the retaining ring.
2.
Remove the swivel from the housing.
3.
Pull the race out of the housing.
4.
Remove the compression spring from the housing.
2.5 Tool Module Swivel Installation
1.
Make sure housing is clean of debris.
2.
Apply a thin coat of
MobilGrease
®
XHP222 Special
grease on the spherical inner contour of the
race.
3.
Insert the swivel into the race and secure from opposite side with the retaining ring. Note: If
retaining ring is a snap type ring use snap ring pliers to install the retaining ring.
Figure 2.3—Tool Module Swivel Installation
