ATI Technologies SX160, Manual Installation, Use And Maintenance

Page: 19 / 24

UK - Manual installation, use and maintenance.
210-0203_Libretto_SX-ind_ATI_2021-02_GB.docx
19 Ed 2021-02
20. GAS CHANGE
To change the gas, use only the special gas conversion kit prepared by the manufacturer, indicated in the table below, carefully
following the following instructions contained in the kit.
Device SX160 SX220 SX300 SX400 SX600 SX800
G20
Kit code AKMETSX160 AKMETSX220 AKMETSX300 AKMETSX400 AKMETSX600 AKMETSX800
P. entrance 20 mbar 20 mbar 20 mbar 20 mbar 20 mbar 20 mbar
P. output 12.2 mbar 12.5 mbar 12.5 mbar 12 mbar 13 mbar 12.5 mbar
G31
Kit code AKPROSX160 AKPROSX220 AKPROSX300 AKPROSX400 AKPROSX600 AKPROSX800
P. entry 37 mbar 37 mbar 37 mbar 37 mbar 37 mbar 37 mbar
P. output 27.5 mbar 25 mbar 27.5 mbar 27.5 mbar 27.5 mbar 27.5 mbar
Model SX160
1)
Switch off the appliance, close the gas interception valve and disconnect the power supply
2)
Remove the burner door (A) and the insulating material (B)
TRANSFORMATION OF GAS SUPPLY
TO PROPANE G31
TRANSFORMATION OF GAS SUPPLY
TO METHANE G20
3)
Unscrew the 4 screws (C), position the mask
(D) in front of the burners and tighten the
screws (C)
3)
Unscrew the 4 screws (C), remove the mask (D)
in front of the burners and tighten the screws
(C)
4)
Replace the injectors (E). Be careful not to lose the sealing washers
5)
Start up the appliance and check the tightness of the gas circuit with a special spray
6)
Put the burner door (A) and the insulating material (B) back in their original positions and tighten
with the fixing screws.
7)
Adjust the burner pressure, according to the indicated value, using the REG screw on the gas valve.
The P.OUT pressure point can be used to check the value
8)
Attach the label contained in the kit to indicate the new type of gas supply