ATI
Model F12/D Gas Transmitter
Part 4
– Operation
37
O&M Manual (Rev-H)
4.5 Main Menu
Main Menu
The main menu provides direct access to the sensor calibration methods, data logger graph, and
transmitter settings.
Figure 39. Main Menu
Alarm Active Menu
When a gas or trouble alarm is active, the following menu appears in place of the main menu.
Figure 40. Alarm Active Menu
4.6 Setup Menu
Figure 41. Setup Menu.
Item
Select to …
Zero
Calibrate the gas sensor zero reading (see Sensor Zero Calibration on
page 41).
Span
Calibrate the gas sensor sensitivity (see Sensor Span Calibration
on page 42)
Graph
View the contents of the logged data as a graph (see
Data Log
on page 61).
Setup
View and configure transmitter settings (below).
Item
Select to
…
Alarm Status
View the Alarm Status Menu and clear manual reset alarms. This
item appears only if a gas alarm is active (see Figure 67. Alarm Status
on page 51).
View Trouble
View the Trouble Status Display This item appears only if the
trouble alarm is active (see Figure 71. Trouble Status Display on
pg 53).
Menu
View the Main Menu (above).
Item
Select to …
Sensor
Configure sensor settings, auto-test, and calibration methods
(see
4.7
Sensor Menus, Methods, and Settings
, on
next page below
Alarms
Configure the three gas alarms (see
4.8 Alarm Menus, Methods,
on pg 48)
Datalog
View the data log graph (see 4.9 Data-log Menus, Methods,
on pg 59).
I/O
Configure the 4-20mA output, serial communications, and relay
operation (see on pg 64).
Panel
Configure the display contrast and backlighting, and panel
security (see on pg 70).
System
Set the real-time-clock, site name, and view version information
(see 4.12
on pg 77).
Menu
Zero Graph
Span ►Setup
>Menu
Alarm Active
►Alarm Status
View Trouble
Menu
>Menu
Setup
►Sensor I/O
Alarms Panel
Datalog System
>Menu>Setup
