7. LED Controller
1. LED Controller - mounting instructions
To derive the heat, we recommend the installation to allow sufficient space for the air to circulate and the driver will not be overheated. Make
sure that all connections are tight. The signal line should be as far away from the power line (230V).
2. „Connect“ Touch-Remote with LED Controller
1. Switch on the Power of the RF Controller and wait ca. 1s and then push the “ON” button on the Touch-Controller,
after that the LED flashes up 3 times, then the Touch-Controller and the Controller are connected.
2. If this step isn’t working please try again.
3. „Disconnect“ Touch-Remote with LED Controller
1.
Switch on the LED stripe and wait ca. 1s and then hold the S+ button again till the stripe flashes up 9 times,
then the Touch-Controller and the bulb are disconnected.
2. Now you can address the stripe again with the same or another Touch-Controller.
4. Programs
1. White RGB
2. Red
3. Green
4. Blue
5. Fade In Fade Out
6. Ramp Up
7. Ramp Down
8. Color Flash
9. Shop Window
10. White Strope
11. Color Change
12. Disco
13. Fire
LED Mixit Set, RF RGB 2,5 m
Product m
anual
Artikel: AT.AR.D021.846.0
© 2018 AtexLicht
Alle rechten voorbehouden
Productdata onder voorbehoud van fouten en aanpassingen zonder kennisgeving.
www.atexlicht.nl
[email protected]
