ATEN VK1100, User Manual

Page: 140 / 176

ATEN Control System User Manual
130
Click to add a drop menu into a Command string, then enter the
number sequence in the brackets []. The Function name must include
an Astrix (*) for each drop menu in the Command string.The drop-
down menu will appear where the (*) is entered in the Function name.
Click to add an Enter into the Command string.
Click to open a list of commands to add into the Command string.
Š
Settings – Use the drop-down menus to set the: Baud Rate , Data Bit , Stop
Bit , Parity, Flow Control and Mode settings.
Š
Advanced – Click to use the Delay Interval drop-down menu to set a
timed delay for each command before it is sent to the device.
Š
Function List – Use this section to configure the device functions by
adding actions to the list.
String Format – Use the buttons to select HEX or ASCII .
Function – Lists the actions created for a device. A Function name
must include an Astrix (*) if you are adding a drop menu to the
Command string. Double click to edit the function name.
Command – Shows the command string created for the action. Double-
click to edit the string.
Feedback – Provides the Retrieve and Send buttons used to test the
command strings.
Retrieve – To use this button refer to the instructions on page 136.
Send – To use this button refer to the instructions on page 136.
Text Command Tools
The following formats allow you to enter command strings with text that
provide special features. These formats work in Serial and Ethernet commands.
Š
() entering text in () allows the command to be edited in the VK6000.
Example : (A1 A9) (A8 B6) – this command string will provide two
editable text boxes from the VK6000 in the Button Action - Commands list
which allow you to change the command string: