- 12 -
Installation
Refer to the installation diagram on the next page (the numbers
in the diagram correspond to the numbers of the steps) and do
the following:
1. Connect the HDMI input port on the VE882T/VE892T to the
HDMI output port on your video source device using HDMI
cable.
2. Connect one end of the fiber optic cable (LC, single mode) to
the Optical Out port on the VE882T/VE892T.
3. Connect the other end of the fiber optic cable (LC, single
mode) to the Optical In port on the VE882R/VE892R.
4. Use an HDMI Cable to connect your video display to the
HDMI output port on the VE882R/VE892R.
5. Plug the power adapter cable into the power jack on the
VE882/VE892.
6. (Optional) Connect your computer or controller system (RS-
232 Port) to the terminal block on the VE882/VE892 to
perform serial commands.
7. a. Connect an IR Transmitter/Receiver to the IR port on the
VE882T/VE892T.
b. Connect an IR Transmitter/Receiver to the IR port on the
VE882R/VE892R.
Note:
The IR transmitter or IR receiver can be plugged into
either the VE882T/VE892T or VE882R/VE892R unit
depending on the device you want to control remotely.
1. Make sure that the power to any device that you connect
to the installation has been turned off. You must unplug the
power cords of any computers that have the
Keyboard
Power On
function.
2. Make sure that all devices you will be installing are
properly grounded.
3. Do not look directly at the light coming from the fiber optic
connectors and cable as it is harmful to the eyes.
