ATEN VE802, User Manual, Page: 14 / 24

Chapter 2
Hardware Setup
Setting Up
Setting up the VE802 HDBaseT-Lite Extender system is simply a matter of
plugging in the cables. Make sure that all the equipment to be connected are
powered off, then refer to the installation diagram on the next page and do the
following:
1. Connect the HDMI Input Port on the VE802T to the HDMI Output Port on
your video source device using HDMI cable.
2. Connect one end of the RJ-45 cable to the HDBaseT output port on the
transmitter. Then connect the other end of the RJ-45 cable to the HDBaseT
input port on the receiver.
3. Connect the HDMI Output Port on the VE802R to the HDMI Input Port on
your video display device using HDMI Cable.
4. Plug the power adapter into the power jack on the VE802T.
(Optional) Plug the power adapter into the Power Jack on the VE802R if
necessary.
5. (Optional) Connect you computer or controller system to the terminal
block on the VE802 to serial commands
6. (Optional) Connect an IR Transmitter/Receiver to the IR port on the
VE802T/VE802R.
1. Important safety information is provided on page 13. Please
review it before proceeding.
2. Make sure that the power to all devices connected to the
installation are turned off. You must unplug the power cords of
any computers that have the Keyboard Power On function.