ATEN VanCryst VE8900, User Manual

Page: 89 / 122

Chapter 6. CLI Commands
77
Disabling a Video Output
To disable video output from a specific receiver or on a particular video wall,
type the command in this format:
blank o<port
>
| f<video_wall_ID> + on | off + \r\n
Examples

To disable video output on the VE8900
receiver with the IP address of
10.0.90.22, type blankscreen o10.0.90.22 on
 To enable video output on the video wall with the Video Wall ID 0, type
blankscreen f0 off
Control Description
o<port> Indicates the device ID, MAC ID, or the IP address of the output
(VE8900 / VE8950 / VE8952 receiver) device you wish to disable
the video output from, or use * to disable video output from all
VE8900 / VE8950 / VE8952 receivers in the setup.
<video_wall_ID> Indicates the ID of the video wall on which you wish to disable the
video output. You can substitute this ID with the ID of any VE8900 /
VE8950 / VE8952 receiver used in the target video wall. To look up
video wall IDs, see
Looking Up System Settings , page 73.
on Stops video output from the specified VE8900 / VE8950 / VE8952
receivers or on the specified video wall.
off Allows video output from the specified VE8900 / VE8950 / VE8952
receivers or on the specified video walls.
\r\n Ends the command.