- 10 -
Installation
To set up the UH3234, use the diagram on the next page (the
numbers in the diagram correspond with the numbered
instructions below), and do the following:
1. Plug in a USB-C PD power adapter to the USB-C DC In port
on the UH3234.*
2. Power on your laptop and use the USB-C Host Connector to
connect the UH3234 to the host laptop.
3. For a dual-view display, connect the UH3234’s HDMI or VGA
port to a monitor, and then the DisplayPort to another monitor.
4. Use an Ethernet cable to connect the Gigabit LAN port to an
Internet connection.
5. Insert an SD or Micro SD card into the card reader slot.
6. Use USB cables to connect USB peripheral devices to the
USB 3.1 Gen 1 Type-A ports.
7. Use audio cables to connect to the 3.5 mm Stereo Audio
Jack.
*
Please plug in the USB-C charger to the USB-C DC In port
before using the dock, as plugging or unplugging of the USB-C
charging port may cause a momentary disconnect on the USB
devices connected to the docking station.
1. Make sure that the power to any device that you
connect to the installation has been turned off.
2. Make sure that all devices you will be installing are
properly grounded.