ATEN ES0152, User Manual, Page: 16 / 300

ES0152 / ES0152P CLI User Manual
4
2-1 Login
3. The command-line interface (CLI) is a text-based interface. User can
access the CLI through either a direct serial connection to the device or a
Telnet session (Default IP address:
192.168.0.1 ). The default username is
admin. A preprogrammed password (inside the red square box below)
unique to each switch is provided on the sticker of the bottom side of the
switch. An example is shown:
If you are logging in for the first time or if you are sure that the password has
not been changed, use the preprogrammed password.
Note: This password is used for both CLI and web GUI interfaces, if it was
changed in either of the interfaces, use the new password to log in.
After you log in successfully, the prompt will be shown as “<sys_name> # “ .
See the following figures. It means you behave as an administrator and have
the privilege for setting the Managed Switch. If you log in as a guest instead of
an administrator, the prompt will be shown as “<sys_name>>”. It means you
behave as a guest and are only allowed to set the system under the
administrator. Each CLI command has its privilege.
Example:
Username: admin
Password: F759a987
(example only*)
ES0152#
Note:  For “<sys_name>#“, we will use ES0152 as an example for our
ES0152 / ES0152P CLI User Manual.
 The password should be retrieved from the bottom sticker of the
switch.