CM5000 User Manual
UM-CM5000-FW3.5.2.0-REV0.0
2019-07-08
www.ateme.com
Page 42
Note
If you want to import a preset from a file to a slot, you can load it using [GC1], then save it using [GC2].
Afterward, you may optionally use the discard button [GC3] to show the settings the remuxer is using.
4.3.6. System Tab
This tab allows you to configure the system settings, monitor and manage the equipment.
Figure 4.7. Web Interface - System Tab
• [GC1]: Button used to import a settings package.
• [GC2]: Button used to export a settings package.
Table 4.8. Web Interface - System Tab Settings
Overview
General information about the unit (name, serial number, version, tem-
perature, uptime) and the extension boards (slot, board, status, revision).
Time
Time settings (Time, GMT offset, NTP, PTP).
Network
Network settings (Network interface, VLAN, route, VPN).
Automation
Automation management.
Assets
Assets management (logo, font, public keys CSV).
Alarms
Alarms settings.
SNMP
SNMP settings (Trap targets, SNMP passwords, MIB download).
Misc
Miscellaneous settings (BISS injected ID, GUI pass-
word, statmux port, redundancy, remote syslog).
Firmware
Firmware management (Upgrade, backup, backup restoration).
Licenses
Licenses management.
Troubleshooting
Access to information needed to resolve issues (re-
boot, current alarms, logs, debug package, etc.).
