TH-3060-UFL Page 4 of 4
Back of Display
WALL
atdec.com | atdec.com.au
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20190814
7.
Adjust Arm movement if necessary
5mm Allen Key
4mm Allen Key
WALL
+
_90°
+
_180°
+
_90°
Back of
Display
Socket Wrench
LOOSEN
TIGHTEN
(+kg)
(-kg)
-5°
+15°
+
_5°
8.
Adjust tilt and roll if necessary
9.
Cable Management
Position your display to the
desired viewing angle using the
angular movement allowed by
the double ball mount.
Depending on the weight of
the Display, it may be necessary
to make adjustments to the
double ball mount. If the display
does not hold its position, or is
too resistant, adjust the tension
plate located at the rear of the
double ball mount.
To adjust the tension plate,
apply half a turn at a time to
each nut. ENSURE NUTS ARE
ADJUSTED EVENLY.
CHECK THE DISPLAY, and then
adjust again if necessary.
