Cable
Balls (x2)
Cable
Clips (x2)
Tension Plate
3mm Allen Key
TIGHTEN
(+kg)
LOOSEN
(-kg)
Installation Complete
Step 6. Adjust the VESA Ball Mount
C
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 09.05.12
Position your Display to the desired viewing angle using the ±20° tilt
allowed by the VESA Ball Mount.
Step 3. Attach the VESA Plate to your Display
There are two mounting
hole configurations:
• 75 x 75mm
• 100 x 100mm
Choose appropriate
Mounting Screws from
the Hardware supplied
to suit your Display.
Step 4. Attach your Display to the Quickshift Mount
HOOK
Back of Display
Quickshift Mount.
Hook the top of the VESA plate onto the
Press and hold the Release Buttons. Gently
push bottom of VESA Plate into Quickshift
Mount. Release Buttons to lock in place.
PUSH
Release Button
(Optional) Insert the Security Screw, and
tighten using a Phillips-head Screwdriver.
TIGHTEN
Phillips-head
Screwdriver
Security Screw
Step 5. Adjust the height of the Quickshift Donut
CLOSE
Open the lever to loosen the
Quickshift Donut.
If necessary, adjust the tension
between the Donut and the Pole
using the 5mm Allen Key supplied.
OPEN
Slide the Quickshift Donut to
desired position.
If the display does not hold its position, or is too resistant, adjust the
Tension Plate located at the rear of the VESA Ball Mount.
To make any adjustments, use the 3mm Allen Key supplied. Apply half a
turn at a time to each screw on the Tension Plate to adjust evenly.
Check the display, and the adjust again if necessary.
Step 7. Cable Management
Connect cables to your Displays, routing
them down to the rear of the poles.
Push the cables into the slots, using either
the Cable Balls or Cable Clips to secure
them to the pole as shown.
Note:
Ensure enough slack is left in cables
to allow for movement. When the slot in
each pole cannot be used, use the supplied
Cable Clips to secure the cables.
OR
TIGHTEN
LOOSEN
Close the lever to lock the
Quickshift Donut in place.
Mounting Screws (x4)
VESA Plate
Top of
Display
Back of Display
75mm
100mm
75mm
100mm
