AWMS-2-BT75-FS Page 4 of 4
7.
Fine Adjustment
6.
Mount Top Display
ii
iii
iv
i
LHS &
RHS
TOP &
BOTTOM
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice.
©
20220905
6.1
Check that distance
between Brackets is equal
to or greater than the
height of the Display.
Repeat Step 5 to secure
top Display and set tilt
angle.
Lower
Close
Adjust angle
Set angle
i
ii
iii
iv
Unstacked
Stacked
Cables can
exit from the
side of the
cable cover
PUSH
PUSH
PUSH
8.
Manage Cables
8.1a
Load cables into
cable clip.
8.1b
Insert one side of the
cable clip into a channel
on the post, then push in
the other side.
Load cables into
cable cover
8.2a
Load
cables into
cable cover.
8.2b
Clip the cable cover
back onto rear post
channels.
7.1
To correct horizontal angle
of d/- 3 °:
Turn a single fine adjustment
knob to adjust angle of
screen.
Clockwise = Higher
Anti-clockwise = Lower
7.2
To close small gap between
di/-6mm (1/4”):
Turn both fine adjustment
knobs - alternating sides a few
rotations at a time.
Clockwise = Higher
Anti-clockwise = Lower
ii
iii
iv
i
LHS &
RHS
TOP &
BOTTOM
FINE HEIGHT ADJUST
FINE ADJUSTMENT
KNOBS
NOTE
Ensure clips are in
CLOSED
position after
fine adjustment complete
