AWM-W35 Page 2 of 2
3.
Install top cap
4.
Cable clips
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©
20221101
Phillips Head
Screwdriver
Top Cap
3.1
Attach Top Cap
4.1
Push the cable down into the Cable Clip.
4.2
Insert one side of the Cable Clip into
the Channel on the Post assembly or Wall
Channel, before pushing the other side in.
NOTE:
Cable clips sold separately
in packs of four.
2. Fit channel clamp to wall channel
2.1
Ensure knob is undone.
2.2
Slide clamp into channel.
2.3
Hold clamp in desired position on
post and turn knob to lock in place.
1. Ensure Knob is undone
Push knob to
aid insertion
Tip: push knob
to aid insertion
2. Slide clamp into channel
3. Hold clamp in desired position on post and turn
knob to lock in place
1. Mount the Wall Bracket to the Wall
8mm (
5
/
16
”) holes
Nylon anchors
M6 x 50mm
Screws
4mm (
5
/
32
”)
holes
Stud
M6 x
50mm
Screws
OPTION 1:
Masonry
OPTION 2:
Timber stud
Using the Wall
Channel as
a template,
mark the
three fixing
hole positions
for drilling.
NOTE:
On a Stud
Wall, use a good
quality Stud Finder
to position mounting
fasteners in the
centre of studs.
NOTE:
Wall Channel
must be level. Verify
using a quality spirit
level tool positioned
along the side edge
of the wall channel.
OR
x3
