AF-AT Page 4 of 4
Cable
Stop
Cable
Clip
Note: Ensure enough cable
slack is given to allow for
movement.
Lock Slot
Elbow Joint
‘click’
‘click’
Lock Slot
Elbow Joint
‘click’
‘click’
9.1
Unlock Handgrip ensuring both the
screen and arm assembly are supported
10.1
After plugging in your cables,
install the Cable Covers.
Insert Cable Covers
up into Lock Slots.
10.2
Push Cable Covers away from
Elbow Joint to secure in place.
9.2
Lift/Lower the Screen to the desired
height. Move both Screen and Arm
assembly together
9.3
Lock Handgrip firmly
10.3
Cable Clips and Cable Stops can be installed
to further manage cables.
9.
Adjusting Height
10.
Cable Management
11.
Insert Cable Stops
Note:
Press down firmly onto
the other edge of the Cable
Stop and hold. This allows the
rear profile to flex in place
11.1
Insert Cable Stop on one edge
of the Pole Slot
11.2
Insert allen key into top cap
on pole
12.
Adjusting the Display Bracket
Allen Key
Storage
atdec.com | atdec.co.uk | atdec.com.au
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©20191024A
Portrait/ Landscape
Tilt
(Screen angle up/down)
Pan
(Screen angle left/right)
No Allen Key
necessary
No Allen Key necessary
Note:
Support Screen when
adjusting tilt.
100mm
75mm
100mm
75mm
5mm Allen Key
Tighten
Loosen
VESA
75 x 75 / 100 x 100mm
