AD-WM-9080 Page 4 of 4
Display Tilt
Display Rotation/Level Correction
No portion of this document or any artwork contained herein should be reproduced in any way without
the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer
reserves the right to alter specifications without notice. ©
20220112
MAINTENANCE
ADJUSTMENTS
CABLE MANAGEMENT
B5. Secure the Display
•
Tighten fasteners and check if the mount is secure and safe to use at regular intervals (at least every three months.)
•
Please contact your distributor if you have any questions.
•
Use the pre-installed cable management clips to route
cables along the arms of the mount.
•
Ensure that cables will not become tangled in the arms
during motion.
B5.1.
Position the four Security Clips
Y
behind the Display
brackets as shown, ensuring that the flange on each
Security Clip is aligned with the rectangular slot on
each Display Bracket.
B5.2.
Secure each Security Clip
Y
using Security Screw
F
.
-5° / +10°
+/- 5°
Y
F
Align Security Clip to Slot
To adjust rotation friction, loosen or tighten
the two nuts below the Display Arms using
supplied spanner
H
or a socket wrench tool.
WARNING:
Only loosen, do not remove the two nuts.
NOTE:
• Pulling and holding the spring-loaded levers
outward will allow the lever handles to rotate
without adjusting the tilt tension. This will allow
for additional adjustment range.
• Alternatively, use a suitable hex key tool to
adjust the tilt tension.
