AD-WM-5060 Page 2 of 4
1. Mount the Wall Plate
2. Detatch the Display Bracket from the Arm Assembly
3. Attaching Arms to Wall Plate
1
2
3
NOTE:
• Choice and supply of appropriate wall plate fasteners is the
responsibility of the installer.
• Consult a preferred fastener supplier or a structural engineer to
select fasteners which are most appropriate for the weight of the
display and wall construction method.
• Wall plate
must
be level. Verify using a quality spirit level tool.
• On a Stud Wall or Drywall use a good quality Stud Finder to position
mounting fasteners in the centre of studs.
• On a Masonry Wall avoid positioning Wall Plate mounting fasteners
in a mortar join.
*Fasteners shown for example only
2.1.
Using Spanner
G
, loosen
the upper bolts on the rear
of the display bracket.
DO NOT FULLY REMOVE.
Ensure nuts remain fully
engaged on thread.
2.2.
Fully remove the lower
bolts from the rear of the
display bracket.
2.3.
Unhook the display bracket
from the main arm assembly.
3.1.
Angle the arm and hook the assembly over the top of the Wall Plate.
3.2. (OPTIONAL)
At this stage, you may choose to fine tune the final alignment of the display
by horizontally sliding the arm assembly left or right within the allowable range - where
the holes on the display bracket align with those on the wall plate.
