1. Construct the Camera Mount Assembly
A2. Attach the Camera Mount Assembly to the cart
A - FOR AD-TVC-20 CART
AD-TVAC-CM Page 3 of 6
> 4 mm
Attach Camera Shelf
B
to Upright Bracket
A
with M5 Screws
C
.
For
AD-TVC-70A
, loosen the screws on the
pre-installed silver clamp plate using Hex Key
D
.
Leave a 4mm gap between the clamp plate and
upright bracket.
For
AD-TVC-20
,
AD-TVC-45
and
AD-TVC-75
,
remove the silver clamp plate completely.
A2.1.
Remove the rubber cable management
grommet from the slot on the cart.
A2.2.
Determine the two holes needed on
Upright Bracket
A
to hold the Camera
Mount Assembly at the desired height.
A2.3.
With assistance, hold the Camera Mount
Assembly sideways (as illustrated)
and align the lower of the two holes
with the hole directly above the cable
management slot on the cart.
A2.4.
Insert M6 Screw
H
with Washer
J
through
Upright Bracket
A
and into the hole on
the cart.
A2.5.
Attach M6 Flange Nut
I
to M6 Screw
H
inside the cart column through the cable
management slot. Tighten using 5mm
Hex Key
D
.
TIP:
Use Spanner
F
to support M6 Flange
Nut
I
whilst tightening M6 Screw
H
.
