
BATTERY REPLACEMENT
-Remove the lamp hood by loosening the two screws as shown in figure 1, and then
gently pull the light hood away from the light.
-Unscrew the battery cover; pull out the battery and its terminals to replace the 6V sealed
lead-acid battery.
-Replace the battery cover, attach the lamp hood back on securely and tighten the two
loosened screws.
BULB REPLACEMENT:
Description: 6V H3 Halogen Bulb.
-Remove the lamp hood by loosening the two screws as shown in figure 1, and then
gently pull the light hood away from the light.
-Unplug the wire that goes to the bulb.
-On the back of the bulb reflector, squeeze the two prongs of the bulb holder until the
spring holding the bulb in releases.
-Lift the bulb out of the reflector unit.
-Replace the burned-out bulb with a new one and re-assemble the lamp in reverse order
of the instructions above.
NOTE: Use extreme caution not to touch the new bulb with your fingers as oils from
your skin will create hot spots on the bulb that will lead to its failure.
Figure 1
Figure 2
IMPORTANT: BATTERY DISPOSAL
The Lead Acid Battery contained in this unit should be disposed of properly once it is no
longer going to be used. Some states have specific disposal regulations. Please contact
your local authorities to find out the disposal rules.