2
Model: ATD-7462
Capacity: 2 Ton
Before oper
ng this device, be sure to read all content within this manual, ensuring that you understand the
oper
ng procedures, maintenance requirements and all safety warnings. The owner and/or operator shall have
an understanding of the product, its opera ng characteris cs, and safety opera ng instruc ons before oper
ng
this device. Safety informa on shall be emphasized and understood. If the operator is not
Ň
uent in English, the
product and safety instruc ons shall be read to and discussed with the operator in the operator’s n
ve language
by the purchaser/owner or his designee, making sure that the operator comprehends their contents.
x
Study, understand and follow all instruc ons before opera ng this device.
x
Do not exceed the rated capacity stated.
x
Use only on hard level surfaces.
x
Use only for emergency re changing or for moun ng re chains.
x
Never get beneath the vehicle when it is supported by the jack.
x
If the vehicle is pushed o
ī
the jack, discard jack. Do not reuse.
x
Li only on areas of the vehicle as speci
Į
ed by the vehicle manufacturer.
x
No alter
ons shall be made to this product.
x
This jack should be used as an emergency device only.
x
Failure to heed these markings may result in serious personal injury / property damage.
x
Prior to each use, visual inspec on (See Pg. 3) shall be made to the device by checking for abnormal
condi ons, such as cracked welds, leaks, and damaged, loose, or missing parts.
x
Consult the vehicle owner’s manual to determine the loca on of li points.
x
Ac vate hazard warning
Ň
ashers and turn o
ī
the vehicle.
x
Be sure to set the vehicle in park with the emergency brake on and wheels securely chocked in both
direc ons.
x
Be sure that the vehicle and the jack are on a hard, level surface.
x
Follow the re-changing procedures or re-chain moun ng procedures speci
Į
ed in the vehicle
manufacturer’s owner’s manual.
x
A
ch the handle assembly to the eyehole and use as a handle to raise and lower the jack.
x
Turn the handle counter-clockwise to lower the jack to its lowest posi on.
x
Posi on the jack under the speci
Į
ed li point.
x
Begin li ing by turning the handle assembly clockwise.
x
Ensure that the saddle is in the correct posi on and located under a vehicle manufacturer designated
li ing point before vehicle contact has been made.
x
Li only to the point that the desired outcome can be reached. Do not over extend this jack.
IMPORTANT: READ ALL INSTRUCTIONS BEFORE USE
ACTIONS TO HELP PREVENT DANGEROUS SITUATIONS
SETUP
ASSEMBLY
LIFTING
