ATD Tools ATD-7227B, Owner'S Manual

Page: 3 / 6

3
17
15
16
8
1 2
1 2
1 2
3
1 2
2 1
1 8
2
1
10
8
6
8
8
6
1 3
1 4
1 9
Figure 1
7
4 5
9
4 5 9
11
22
20
1 3 1 4
4 5 9
4 5 9
23
Assembly
Operation
• A�ach the swivel caster (#16) to the base frame (#1) using (4) M8 x 16 hex bolts (#17) and (4) M8
hex locknuts (#15) NOTE: When a�aching the swivel caster assembly, insert the bolts so that when
the stand is upright, the hex locknuts will be facing upwards.
• Assemble the caster part (#19) to the Caster Carrier (#11), Separate Crank Handle (#20)
by taking out the B Pin (#23) from Roll Pin (#22). Put Slide Weldment (#21) into the Carrier (#11),
assemble and lock the Crank Handle (#20) with Roll Pin (#22) and B pin (#23).
• Insert the upright assembly (#2) onto the frame (#1) using M12 x 110mm hex bolts (#12), (3) M12
nuts (#13) and (3) M12 flat washers (#14).
• Assemble the support braces (#6) to the frame (#1) and upright assembly (#2) by a�aching the
support braces to the bracket (#7) of the frame and upright assembly (#2) by using (4) M8x30mm bolts
(#8), flat washers, lock washers & nuts (#9, #5, #4). NOTE: Make sure the support braces are located
on each side of the frame bracket and the assembly bracket.
• Insert the assembled Caster Carrier (#11) and Caster Assembly Part (#19) onto the frame (#1) using
(2) M12 x 100mm hex bolts (#12), (2) M12 nuts (#13) and (2) M12 flat washers (#14).
• Place the bo�le jack (#3) onto the upright assembly (#2). Refer to diagram. NOTE: Screw out
the bo�le jack extension screw so that the upright assembly will rest on the bo�le jack.
• A�ach the safety chain (#10) by pu�ng the links into the slots on the upright assembly (#2)
Suppor�ng a Load
• Raise the vehicle so that the wheels that are to be removed are clear of the ground.
• Ensure the vehicle is properly supported and that the wheels not being removed are properly
blocked. Ensure that the emergency brake is ac�vated.
• Ensure that the wheels are straight in order to make the removal easier.
• Lower the dollys li�ing arms by turning the release valve fully counter clockwise and posi�on
the dolly under the wheel that is to be removed.
• Loop the safety chain around the wheel being removed and make sure they the chain is snug
but not over �ghtened before a�aching it to the connec�ng points.
• Raise the dolly li�ing arms by turning the release valve clockwise on the hydraulic unit. Pump
the handle of the hydraulic unit un�l the li� arms are suppor�ng the weight of the �re.
• Once supported, you can remove the �re from the vehicle.