ATC SunRay RF, Installation And Operating Manual

Page: 10 / 16

10
Pairing
Gateway
Once the Gateway is
connected to the Internet and
registered in the web portal,
the devices must be paired to
it. To do this, put the Gateway
in discovery status press the
Link button for 3 seconds.
3
.
The orange LED starts to flash.
Once the pairing button has been pressed, you
have one minute to add a device: for each new
device, the time available increases.
Power Meter
To pair the Power Meter, press with a clip
(supplied) on the small push button on the top of
the Power Meter. Look at the Power Meter LED
to check that it is paired.
• Not paired: LED off
• Paired correctly: the LED flashes once every two and a half
seconds.
• Paired but lost: the LED flashes once every half a second. This
happens when the Gateway is disconnected, for example. Once
communication with the Gateway is possible again, the Power
Meter will connect again automatically.
Status of the Power Meter LED
Installation instructions
orange
green