-4-
ATC Electrical & Mechanical,
ATC House, Broomhill Drive, Tallaght, D24 EF99, Ireland
IE: 01 4678301, UK:0203 564 9164, Email [email protected]
All infra red radiation heaters are designed to achieve and maintain a certain thermal
comfort to the people who need it, therefore it is very important to carefully study the
occupied area where people stay and consequently direct the heat towards them.
OPERATION INSTRUCTIONS
Read the instructions contained in this booklet carefully before using the appliance. ATC
cannot assume any responsibility for damage to property or personal injury resulting
from failure to abide by the instructions given in this booklet. Following these instructions
will insure a long service life and overall electrical and mechanical reliability. Keep this
instruction booklet in a safe place.
DESCRIPTION
ATC SIENNA is an extremely versatile heater that works with infrared rays. It can be used
in many different situations and is a very useful Heater for various different jobs. The heat
is immediate and the electricity consumption is very low, it only takes up a little space
although it heats a very wide area. The Sienna is built and developed with the best quality
components in accordance with all legal regulations and certified for safety in use.
INSTALLATION TO WALL
Install the heater on the wall at least a minimum distance of 0.32m from the ceiling (see
installation examples pages 10 and 11).
The height at which the heaters are normally installed varies between 2.7 to 3m Max for
the single version and from 3.4 to 4m Max for the double element heater.
Wall mounting is the best solution to achieve the best results in terms of heat
with the reflector at a 45° angle and the element always mounted horizontally.
The appliance must not be placed immediately below a mains socket.
WIRE GUARD - (Supplied with single 2.2kw heater)
• The wire guard should be used if protection is required (for example sports halls or
places where games are played). In areas where indoor football is played, it may be
necessary to fit additional external guarding to cope with the force of impact.
• The wire guard is simply mounted into the holes in the front of the reflector.
• The wire guard must be installed when the heater is fixed under a height of 2,5 m
from the floor level and this assembly must be done during installation and by a
qualified electrician.
• The Sienna protective wire guard has been designed to prevent direct access to the
heating elements and must not be removed while the heater is being used.
• The guard does not guarantee full protection for children or the disabled.
MAINTENANCE OF BULB
(to be performed by qualified staff or specialized technician)
• The guarantee does not cover replacement or repair of bulb.
• Remove dust from the reflector and bulb periodically with brush or compressed air
for best heat efficiency.
• The replacement bulb must be the same as the bulb supplied with the device.
• Replacement with other bulbs may damage the device and cause it to be unsafe.
contact ATC or the retail outlet authorized to sell the
replacement bulb, specifying the model and code of the
purchased heater.
