4
WALL INSTA L L ATION
( c o n t i n u e d )
4 . Install telephone
base on wall jack
Hold the base up
next to the wall jack,
and plug in the line
cord (Figure 3).
Then push the base
against the wall jack
and down until it is
held securely by the
mounting studs.
5 . Set DIAL Mode switch
Refer to step 4 in Table/Desk Installation.
6 . Connect handset to telephone
Connect one end of the coiled handset cord into
the base. Plug the other end into the handset
(Figure 4). Then hang up.
7 . Check for dial tone
Lift the handset and listen for dial tone. If you
cannot hear a dial tone, refer to “In Case of
Difficulty” and try to correct the problem.
N O T E : If you
cannot fit the base
onto the wall jack,
remove the four
non-slip pads.
Figure 4
Figure 3
AT&T 230 Quark pdf 7/22/98 12:13 PM Page 5
