SECTION 503-400-200
Move the ringer volume control lever (Fig. 5)
on the lower edge of the set to check variation
of volume. There is no provision for ringer
cut off using the volume control.
(2) Call the CO dial test line, when connected
press the dial buttons in sequence 1
through 9, *, 0, and
#
verifying that correct
signal is returned from the CO.
(b)
Automatic Dialer.
(1) Record digits 1 through 9, * 0, and
#
into first memory location.
(2) From the telephone set manually dial CO
"dial test circuit."
(3) When test line is connected, depress the
first memory button and verify that correct
signal is returned form the CO.
(4)
Repeat Steps (1), (2), and (3) for memory
buttons two through twelve.
4.
OPERATION
4.01
The memory location buttons are used for
the following functions:
•
To select memory locations
•
To be used as specific digits when recording
or changing telephone numbers
•
To automatically dial prerecorded telephone
number.
A. To Place A Number Into Memory
4.02
Perform the following operations in sequence.
(1) Remove the dialer faceplate by inserting
finger nail into slot at top of faceplate, pull
down slightly and lift out.
(2) Remove the directory sheet and write or
type the desired name(s) and telephone
number(s).
(3) Momentarily depress the RECORD ON/OFF
button (Fig. 2). (A constant tone will be
heard.)
Page
6
(4)
Momentarily depress the memory button
adjacent to the desired name listed on the
directory sheet. (A double interrupt of the tone
will be heard.)
(5) Manually dial the desired telephone number
using the digit designations to the right of
the memory buttons on dialer. (The tone will
interrupt momentarily as each digit is recorded.)
The manual dial key pad
CANNOT
be used to
record a number into memory.
A total of
16-digits can be recorded. When the 16th digit
is recorded, the dialer will beep three (3) times
and automatically end the recording procedure.
If the dialer is inadvertently left in the record
mode it will time out after 1-112 minutes, give
three (3) beeps, and automatically reset.
(6) Momentarily depress the RECORD ON/OFF
button. (The tone will cease and the dialer
will be ready either for automatic dialing or to
record another telephone number into memory.
Repeat steps 3 through 6.)
(7) Replace the faceplate after all numbers have
been recorded.
Note:
The two top name and digit buttons
are illuminated by red and green LEDs. Both
buttons are illuminated for approximately 10
seconds when the handset is taken off hook.
This enables the user to identify important
numbers such as police, fire, etc. especically
in the dark. Other important numbers may
be highlighted by use of the adhesive backed
color dots furnished with the set.
B.
To Change A Number In Memory
4.03
When a new number is recorded in a
previously used memory position it will
automatically replace the previously stored number.
C.
To Delete A Number From Memory
4.04
Perform the following operations in sequence.
(1) Remove the dialer faceplate by inserting
finger nail into slot at top of faceplate, pull
down slightly and lift out.
(2) Momentarily depress the RECORD ON/OFF
button.
BSP
503-400-200-i01_1980-09-06.jpg
Scanned by Frank Harre!!, {Cowboy
Frank) Castle Rock, Colorado
Feb
08, 2012 22:05:17
