6
Getting started
Telephone line cord
DSL filter
(Optional for DSL users,
see Note No. 4 below)
NOTES:
1. Use only the provided power cord. If you need a replacement, visit our website at
www.telephones.att.com or call
1 (800) 222-3111
. In Canada, dial
1 (866)
288-4268
.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-
the-table or cabinet outlet.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL) and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
Telephone base and charger installation
4.
Plug the large end of the larger
power adapter into an electrical outlet
not controlled by a wall switch.
5.
Plug the other end of the tele-
phone line cord into a telephone
jack.
3.
Route cords through
slots.
1.
Plug one end of the
telephone line cord
into the telephone jack
at the bot tom of the
telephone base.
2.
Plug the small end
of the larger power
adapter into the power
jack at the bottom of
the telephone base.
b. Plug the large end
of the smaller power
adapter into an elec-
t r i c a l o u t l e t n o t
controlled by a wall
switch.
a. Plug the small
end of the smaller
power adapter into
the jack on the
underside of the
charger, then route
the cord through
the slots as shown.
c. The battery
may have enough
charge to allow
for some calls.
For best perform-
ance, place hand-
set in telephone
base or charger
to charge for at
least 16 hours
before first use.
