AT&T MERLIN LEGEND Release 3.1, System Programming Manual

Page: 140 / 887

Basic System Operating Conditions
3–4
Common Administrative Procedures
Basic System Operating Conditions
The procedures in this section are all related to the system rather than to the
operation of telephones, operator positions, lines, or trunks.
NOTE:
You must reset the system time when Daylight Savings Time begins and ends.
This section contains the following programming procedures:
■
System Programming Position Assignment
■
System Language
■
System Date
■
System Time
System Programming Position Assignment
Use this procedure to reassign the extension used for system programming. This
extension should not be the same extension as that used for the operator
position. The system programming position can be reassigned only to one of the
first five extension jacks on the first MLX module. Only one system programming
console is allowed per system.
If you are programming on the console, be aware of the following:
■
The console must be connected to the extension currently assigned for
system programming.
■
As soon as you change the system programming extension, the system
programming session is terminated. To proceed with system
programming, you must connect the system programming console to the
newly assigned extension and enter system programming again.
NOTE:
The telephone used for system programming must be an MLX-20L.
Summary: System Programming Position
Assignment
Programmable by System manager
Mode All
Idle Condition Not required
Planning Form Form 1, System Planning
Factory Setting First extension jack on the first MLX module (also set as an
operator position)