Page 3 of 4
Quick Reference Guide For
Merlin II R3 – Station Programming
Station Programming Mode
- Enter
Station Programming
by pulling the switch on the
left-hand side of the phone down to ‘P’. All the following procedures are performed
with the phone in
Station Programming
mode.
Station Programming Procedures
Account Code Entry
- Press the button to be programmed. Dial *82.
Auto Answer-All
- Press the button to be programmed. Dial *75. (This feature is used
when connecting an analog device to a station through a General Purpose Adapter. This
allows the ringing signal to be passed through to the analog device.)
Auto Answer-Intercom
- Press the button to be programmed. Dial *70. This feature is
used to enable HFAI on a Merlin membrane telephone with a speakerphone adjunct.
Auto Intercom (DSS/BLF button)
- Press the button to be programmed. Dial *91 plus
the intercom number of the station.
Automatic Line Selection
- Dial **. Press line buttons in the order of preferred
selection. Dial ** when finished if additional programming will be done to this phone.
Call Coverage
- Press the button to be programmed. Dial *40 for primary coverage, or
dial *50 for secondary coverage. Dial intercom number of station to cover calls for.
Call Forwarding
- Press the button to be programmed. Dial *33.
Call Park
- Press the button to be programmed. Dial *86.
Call Pickup
- Press the button to be programmed. Dial *84. Dial intercom number to
make this button
Call Pickup-Individual
.
Call Pickup Groups
- Press the button to be programmed. Dial *32.
Camp On
- Press the button to be programmed. Dial *29.
Coverage Inhibit
- Press the button to be programmed. Dial *77.
Do Not Disturb
- Press the button to be programmed. Dial *71.
Executive Barge-In
- Press the button to be programmed. Dial *25.
