Installation and setup
Connect the base and install batteries as shown below. After installation, place the
handset in the base and allow the battery to charge for 8 hours before use. You can keep
the battery charged by returning the handset to the base after each use.
Press coin into slot on
base of handset to
release latch, then
remove battery cover.
Insert supplied
batteries.
Place handset in base to charge
for 8 hours before first use.
Rotate antenna to fully upright
position.
Insert top
tab first.
To replace battery cover
Press down to
click in place.
Caution:
Use only the supplied NiCd battery
(80-5469-00-00) or AT&T model 2AA NiMH
replacement battery (SKU 26820).
Do not use
alkaline batteries.
ATT-2525QSG-d3.qxd 1/17/2004 5:21 PM Page 3
