Installation and Operations Manual
AT&T Proprietary (Internal Use Only)
—70—
6.2.2.2 Discovering and Registering the Smoke Detector
Follow these steps to discover and register the smoke detector:
Step
Action
1.
Place the DLC into Discovery Mode in DLD.
2.
Make the smoke detector discoverable by inserting the two batteries.
Alternate Method:
Remove the back mounting bracket (sends tamper
signal).
3.
Confirm that the smoke detector has been discovered in DLD.
4.
Label the smoke detector in DLD.
6.2.2.3 Installing the Smoke Detector
Follow these steps to assemble the smoke detector:
Step
Action
1.
Slide the battery compartment cover away from the unit to unsnap it and lift it
off as shown in Figure 44.
2.
Observing proper polarity, insert the two 3V lithium batteries supplied into the
alarm battery compartment and replace the battery cover.
Figure 44: Smoke Alarm Battery Compartment
