a duty factor not to exceed 50%. In August 1996, the Federal Communications Commissions
(FCC) adopted RF exposure guidelines with safety levels for hand-held wireless devices.
Important:
To maintain compliance with the FCC’s RF exposure guidelines hold the transmitter at least
4 - 6 inchs (10 – 15 centimeters) from your face and speak in a normal voice, with the antenna pointed up
and away. If you wear the handset on your body while using the headset accessory, use only the AT&T
supplied belt clip for this product and ensure that the antenna is at least 1 inch (2.5 centimeters) from your
body when transmitting. Use only the supplied antenna. Unauthorized antennas, modifications, or
attachments could damage the transmitter and may violate FCC regulations.
Normal Position:
Hold the transmitter approximately 4 –6 inches (10 –15 centimeters) from your face
and speak in a normal voice, with the antenna pointed up and away.
Electromagnetic interference/compatibility
The FCC requires that you be advised of certain requirements involving the use of this device.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment uses and
can generate radio frequency energy, if not installed and used in accordance with the instruction,
it may cause harmful interference to radio communications. However, there is no guarantee that
the interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception(which can be determined by turning the equipment
off and on), the user is encouraged to correct the interference by one of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver
3. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
4. Consult the manufacturer for technical assistance.
Accessories
To enhance the use of your ATT650/655 series GMRS transceiver, depending on model
and included accessories, several other approved accessories such as headset, wall
battery trickle charger, along with replacement neck strap, battery compartment door,
and belt clip are available from KNG America. To order accessories, call KNG
America’s Customer Service Department at 1-800 354-8785 during regular business
hours.
Order by the following part numbers to ensure accuracy and quick service.
Item:
Part Number:
Headset:
702500
Wall Charger
702520 (110 VAC 50/60 Hz)
Neck Strap
701230
Battery
door
702240
Belt Clip
702250
Battery installation
Each radio requires four ‘AAA’ size batteries.
