6
7
Turn on Your Device
Plug the power cord into an electrical wall outlet that is not
controlled by a wall switch.
Insert the small end of the power cord into the Power Input
port on the back of your Wireless Home Phone Base.
Press and hold the round On/Off button for 2 seconds until
the signal strength light comes on.
Check the Wireless Signal
Raise antenna to an upright position.
Confi rm signal strength light is green for optimal
performance. Yellow indicates a moderate signal and may
be suffi cient.
Note:
If you do not see a green light (strong signal), you
may want to choose an alternate installation location.
Getting Started
Getting Started
Connect the Device to a Phone
1) Unplug your phone
from your home’s
phone wall jack.
Note:
The “Phone 2” port can be used to connect an
additional phone or answering machine. This port uses the
same telephone number as the “Phone 1” port.
2) Plug your phone into the
“Phone 1” port on the
Wireless Home Phone Base,
using your existing phone
cable or included phone
cable.
IMPORTANT:
DO NOT plug the Wireless Home
Phone Base into your home’s phone wall jack.
On/Off
Summary of Contents for AT&T Wireless Home Phone Base
Page 1: ...UserGuide AT T Wireless Home Phone Device ...
Page 20: ...32 Notes 32 Notas ...
