If you have difficulty operating this phone, try the suggestions below.
For Customer Service, visit our website at
www.telephones.att.com
or call
1 800 222–3111.
Please retain your receipt as your proof of purchase
.
If the phone doesn’t work at all, check these items first:
•
Make sure the AC adapter is plugged into an outlet not controlled by a
wall switch.
•
Make sure the telephone line cord is plugged firmly into the base unit
and the modular jack.
•
Make sure the base antenna is fully upright.
•
If the handset does not beep when you press
P
, the battery might
need charging.
•
Make sure the battery pack is installed correctly.
•
If you have dial pulse (rotary) service on your phone line, make sure
the dial mode is set to dial pulse (see INSTALLATION).
If the above suggestions don’t solve the problem, try re-initializing
the handset and base:
1
Disconnect the power to the base.
2
Remove the handset battery pack.
3
Wait a few minutes.
4
Connect the power to the base.
5
Insert the handset battery pack.
6
Put the handset in the base to re-initialize.
If you hear a two-beep signal when you try to use the handset:
•
You might be out of range. Move closer to the base and try again.
•
If moving closer to the base doesn’t help, try following the directions
above for re-initializing the handset and base.
If the phone does not ring when you receive a call:
•
Make sure the handset ringer is on.
•
Make sure the telephone line cord is connected firmly to the base and
the telephone jack.
•
Make sure the AC adapter is plugged firmly into an outlet not
controlled by a wall switch.
•
You might be too far from the base; move closer.
•
You might have too many extension phones on your telephone line to
allow all of them to ring. Try unplugging some of them.
IN CASE OF DIFFICULTY
19
9345_book_1ATT 6/5/01 11:34 AM Page 19