355AF adapter
Printer
14-Ft. modular cord
(Back view)
Figure 6
Connecting the Control Unit
and Printer to the CAS
6.
7.
8.
Connect your printer's 25-pin male connector to the female connector
labeled Printer on the back of the CAS (Figure 6). Tighten the screws.
NOTE: Make sure that your printer's baud rate is set at 1200. If you are
not able to adjust your printer’s baud rate to 1200, refer to the section of
this document titled "Changing the Baud Rate of the CAS’s Output."
Plug the CAS's power supply into a 3-prong power outlet that is not con-
trolled by a wall switch. The green light labeled Power goes on.
Insert your custom cartridge into the cartridge slot on the front of the CAS
(Figure 7). Push the cartridge slowly and steadily until it is firmly in place.
The red light labeled Ready goes on. If your printer’s ac power cord is
plugged in and its power switch is set to the on position, a system
diagnostics message is printed. If a system diagnostics message is not
printed and all the conditions listed above have been met, refer to this
document’s section titled “Troubleshooting Procedures.”
7
