•
Press and release 6 to begin playing only new messages.
If there are messages, the system plays them and beeps 5 times after the last message. If there are no
messages, or no new messages, the system simply beeps 5 times.
•
To repeat an entire message, press and release 2
while that message is playing.
•
To repeat part of a message, hold down 2.
To resume playing the message, release 2.
•
To skip an entire message, press and release 5
while that message is playing.
•
To skip part of a message, hold down 5.
To resume playing the message, release 5.
•
To interrupt message playback, press and release #.
To resume playing messages,
press and
release 7.
•
To delete only a selected message, press and release 3 while that message is playing.
To be sure
you are deleting the right message, you can press 2 to repeat the message and then press 3 when you
are sure that the system is playing the message you want to delete.
Saving Your Messages
To save messages you’ve just heard, simply hang up the telephone. Any new messages will be recorded
after the saved messages.
Replaying Your Messages
After all messages have been played and you hear 5 beeps,
press and release 7 to replay the messages.
Deleting All Messages
To delete all messages remotely, press and release 7 and then press and release 3 while each message is
playing.
NOTE: To maintain maximum message storage space, use this method if you want to delete all
messages
.
Recording a Memo
After you listen to your messages, you can record a memo to yourself or other members of the household.
1.
Press and release *.
2.
Begin speaking
after the beep.
3.
Press and release #
when you are finished.
This message will be counted as a new message.
Turning On the System
If you forget to turn the system on before leaving home, you can turn it on by calling from a touch tone
telephone. (You do not have to enter your Remote Access code to use this feature.)
1.
Dial your telephone number
and wait for 10 rings. The system will answer and beep twice. (It will
not play your announcement.)
2.
Press and release 0.
The system beeps twice to indicate that the system has been turned on. You can
hang up and the system remains on, ready to answer calls and record messages.
NOTE: If you press 0 and hear 5 rapid beeps instead of the normal 2-beep signal, then either
memory is full or no announcement is recorded.
Memory Full/No announcement
If the system answers after 10 rings and presents 2 beeps instead of your announcement, then the system
may be off, or memory may be full, or your announcement may have been lost due to a power failure with
insufficient battery power.
To set your system to answer calls and record messages:
1.
Enter your Remote Access code after the 2-beep signal.
2.
Listen to any messages that have been recorded and delete some or all of them.
3.
Press and release 4 1 to review your announcement. If you don’t hear your announcement, press and
release 4 * to record a new announcement.
