Answering System 1710
•
Installation
•
At Home Operation
•
Away From Home Operation
Installation
1.
Install the batteries
Open the battery door on the bottom of the unit by pulling on the tabs. Insert the batteries,
then close the door.
The batteries are used to save your messages in the event of a power failure.
2.
Connect the line cord
Plug one end of the telephone line cord into the TEL LINE jack at the rear of the unit, and the other
end into a modular wall jack.
3.
Connect your telephone
(If you do not want to connect a telephone to the system, go to Step 4.)
Plug your telephone set cord into the TEL SET jack at the rear of the unit.
4.
Connect the power cord
Plug the power transformer into an electrical outlet that is not controlled by a wall switch.
The Message Window counts down from 6 to 0, then the
“0”
flashes to indicate that you need to record
an announcement.
At Home Operation
Recording Your Announcement
Before using your new answering system, you should record the announcement that callers will hear when
the system answers a call. The system will not answer calls unless an announcement is recorded.
1.
Prepare your announcement.
Example:
“Hello. I can’t come to the phone right now. Please leave your name, telephone number,
and a short message after the beep. I will return your call as soon as I can. Thank you.”
NOTE: Your announcement can be up to 90 seconds long.
2.
Press and release CHANGE.
The Message Window displays
“C”.
3.
Press and release ANNC.
The system beeps to indicate that it is recording. Speak toward the microphone in a normal tone of
voice, from about 9 inches away. While you are recording, a “-“ flashes in the Message Window.
4.
Press STOP
when you are finished.
The unit automatically plays back your announcement. If necessary, adjust the VOLUME control (on the
right hand side of the unit).
After your announcement plays back, the number in the Message Window should be on steady. If it is
flashing, follow steps 2-4 to re-record your announcement.
Reviewing Your Announcement
To review your announcement, press and release ANNC.
If necessary, adjust the VOLUME control (on the right side of the unit.)
