4.
The system beeps 5 times after the last message is played and then beeps twice to indicate that it is
ready for another remote command.
To stop playing your messages, press and release #.
To resume playing your messages, press and release 7.
Listening to New Messages Only
To play new messages only, press and release 6 after the two-beep signal.
Saving Your Messages
To save messages you’ve just heard, simply hang up the telephone. Any new messages will be recorded
after the saved messages.
Clearing Messages
If you do not want to save your messages, press and release 3 3 after listening to all of your messages. The
tape rewinds and resets so that new messages are recorded over the old ones.
NOTE: To avoid accidental loss of messages, you cannot clear messages until you have listened to
them. If you press 3 3 before listening to your messages, the system will beep rapidly.
Replaying Messages
After all messages have been played and you hear the 5 beeps, press and release 7. You will hear a tone as
the system rewinds the tape to the beginning to replay all messages.
Advancing the Tape
While listening to messages, hold down 5 to advance the tape quickly. The tape will advance as long as you
hold down the key. When you release 5, messages resume playing from that position on the tape.
Rewinding the Tape
While listening to messages, hold down 2 to rewind the tape. The tape rewinds as long as you hold down
the key. When you release 2, messages resume playing from that position on the tape.
Recording a New Announcement
1.
Dial your telephone number and wait for your system to answer.
2.
Enter your Remote Access code during or after your announcement.
3.
Listen to any messages that you have. The system beeps 5 times after the last message is played and
then beeps twice to indicate that it is ready for another remote command.
4.
After the 2 beeps, press and release 3 3 to clear any messages you have. You will hear a long beep as
messages are cleared, followed by 2 beeps to indicate that the system is ready for another command.
5.
After you hear the two-beep signal, press and release 4 * to begin recording the new announcement.
Wait for a long tone followed by a short beep, then begin speaking.
6.
When done, wait a few seconds for a two-beep signal. If you don’t hear this, press and release #.
7.
After the 2-beep signal, press and release 4 1 to listen to your new announcement.
Recording a Memo
This feature is useful if you want to record a memo after you have listened to your messages.
1.
Dial your telephone number and wait for your system to answer.
2.
Enter your Remote Access code, listen to your messages, and wait for the two-beep signal.
3.
Press and release *, and begin speaking after you hear a beep.
4.
When you are finished, press and release #.
Toll Saver
To use the Toll Saver feature, remember to move the RING SELECT switch to TS before leaving home.
