4. Clean the filters below running water.
5. Put the flat filter (C) in the bottom of the
appliance.
6. Put the coarse filter (A) in the microfilter
(B) and push the filters together.
7. Put the filter system in position.
8. To lock the filter system, turn the handle
on the microfilter (B) clockwise until it
locks in position.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
cocktail stick.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a damp soft cloth.
Only use neutral detergents. Do not use
abrasive products, scouring pads or solvents
(e.g. acetone).
What to do if…
The appliance does not start or stops during
operation.
First try to find a solution to the problem (refer
to the chart). If not, contact the service cen-
tre.
Malfunction
Fault code
Possible cause
Possible solution
The appliance does not
fill with water.
The display shows
The water tap is
blocked or is furred with
limescale.
Clean the water tap.
The water pressure is
too low.
Contact your local wa-
ter authority.
The water tap is closed.
Open the water tap.
The filter in the water in-
let hose is blocked.
Clean the filter.
The connection of the
water inlet hose is not
correct.
Make sure that the con-
nection is correct.
The water inlet hose is
damaged.
Make sure that the wa-
ter inlet hose has no
damages.
The appliance does not
drain the water.
The display shows
There is a blockage in
the sink spigot.
Clean the sink spigot.
The connection of the
water drain hose is not
correct.
Make sure that the con-
nection is correct.
The water drain hose is
damaged.
Make sure that the wa-
ter drain hose has no
damages.
The anti-flood device
operates.
The display shows
Close the water tap and
contact the service
centre.
The programme does
not start.
The appliance door is
open.
Close the door correct-
ly.
37
Summary of Contents for VA9111RT
Page 83: ...83...
