Atag VA8117WTC, Operating Instructions Manual

Page: 185 / 212

Status light
The status light at the bottom on the dishwasher provides information by means of 3 different colours.
Status light
Blue - Load more
The program has started, but you can still load more dishes.
Flashing blue indicates that Remote start is activated. In the ATAG Connect Life app, select the
desired program and start the dishwasher.
Red - Do not load
You should not load more dishes (risk of poorer dishwashing result).
A flashing light indicates that the door has been opened while a program is in progress. If it flashes
when the door is closed, an error has occurred. See the chapter Troubleshooting
.
Green - Unload
The dishwashing program is finished. The status light stays on for 15 minutes.
Stopping or changing a program
If you want to change program after starting the dishwasher, open the door then press and hold
Start/Stop for three seconds. Add more detergent if the lid of the detergent dispenser has opened.
Then select a new program, press Start/Stop and close the door.
If you want to load more dishes
Open the door. The dishwasher stops automatically. Add the dishes and close the door. After a
while, the dishwasher continues the program.
If the dishwashing program was started using Remote start, the interrupted program continues when
the door is closed (without the Remote start function).
If the dishwasher is turned off due to a power failure
If the dishwashing program was not finished, the interrupted program continues when power is
restored.
If the dishwashing program was started using Remote start and was not finished, the interrupted
program continues when power is restored (without the Remote start function).
NOTE!
During drying, the program is interrupted if the power is cut or the door is open for more than 2
minutes.
23
Using the dishwasher