Atag VA8015NT, Operating Instructions Manual

Page: 72 / 108

Troubleshooting
Action Type of fault on the display
Clear the drainage pump. See the chapter Care and cleaning. If the problem persists, call the
service department.
Overfilling water 1 F10
See “Water remains in the dishwasher” in the table “Problem” below. If the problem persists, call
the service department.
Water outlet fault F11
Check that the water tap is on. Check that the outer filter on the inlet hose is not blocked. See
Unblocking the inlet hose filter in the chapter Care and cleaning. If the problem persists, call the
service department.
Water inlet fault F12
Turn off the water tap and call the service department. Inlet valve leakage F40
Call the service department. Water level fault F52
Turn off the water tap and call the service department. Overfilling water 2 F54
Call the service department. Circ. pump fault F56
Press any button to clear the error message.
Action Possible causes Problem
Wait a moment then try again. You have pressed the buttons too soon after
opening the door. The buttons do not react when pressed.
See the chapter Settings. Child lock (button lock) activated.
Open the door. The buttons only react to use
when the door is open.
The door is closed.
Clean with a dry or slightly damp cloth. The buttons are dirty.
Check that the baskets are correctly positioned
horizontally.
The baskets are not correctly positioned. Cannot close door.
Check that the dishes are not blocking the
baskets from sliding properly into place.
Check the door lock. If it does not click into place
and lock, open the door.
The door lock does not click into place and lock.
Press and hold the navigation button and
the option button Auto Open for five seconds.
Then wait 30 seconds. Close the door. Check
that the door lock clicks into place and locks.
16