Atag CM4574M, Instructions For Use Manual, Page: 37 / 44

WARNING!
Read and obey the instructions shown on the display. The display shows information and touch
keys to use. Important information is accompanied by an audio signal.
If the given instruction shown on the display or the given remedy in the table below is not the solution
to a problem, contact Customer Services.
Solution Possible cause Problem
Clean the inside of the
appliance thoroughly. The inside of the appliance is
very dirty.
Disassemble and clean the
brewing unit.
Replace or remove the water
filter and/or descale the
appliance as soon as possible. A reminder that the appliance
needs de-scaling and/or the
filter must be replaced.
Turn the milk froth adjustment
knob to ‘CLEAN’. Reminder to clean the tubes
inside the milk container.
Replace or remove the water
filter. Reminder to replace the filter.
Descale the appliance as soon
as possible. Reminder to descale the
appliance.
Warm the cups by rinsing them
with hot water (you can use the
hot water function). The cups were not preheated. The coffee is not hot.
Before making coffee, use the
rinsing function to heat the
brewing unit. The brewing unit has cooled
down because several minutes
have elapsed since the last
coffee was made.
Select a higher coffee
temperature. A low coffee temperature is set.
Adjust the grind level. The coffee is ground too
coarsely. The coffee is weak or not
creamy enough.
Use coffee for espresso
machines. The coffee is not correct.
Adjust the grind level. The coffee is ground too finely. The coffee is supplied too slowly
or a drop at a time.
Adjust the grind level (in the
direction of 1). The grind level is not correct. The slices coffee grounds are
soft and mushy.
37
Troubleshooting