8
Outlined Components
Antenna Connector
The connector for antenna is a standard reverse SMA jack. Simply connect it to a 2.0dBi dipole
antenna (Standard Rubber Duck). It is 50 Ohms impedance and can support 2.4GHz frequency.
Ethernet Port
The connector for network is the usual RJ45. Simply connect it to your network switch or Hub. When
the connection is made, the green color LED of Ethernet port will blink. When data traffic (Rx/Tx)
occurs on the network, yellow color LED will blink during data transferring.
DC-IN Power Outlet
The Device is powered by a 12V DC (Inner positive, outer negative) , 1.0A power supply. Plugging
the power adaptor to the AC power socket and put the DC Jack plug into the outlet of the Device.
T
he “SYS” green color LED will be ON when power is properly supplied. Terminal Block 2 wires
power supply is an option.
Reset Button
If any chance you forgot the login password or have incorrect settings making this Device inoperable,
upon the power is on
and the “SYS” LED light on, use a point tip to press this button and hold it for
more than 20 seconds the release the point tip. The Device will reboot and all the parameters will be
reset to the factory default.
Serial Port of RS-232/RS-422/RS-485
Connect the Serial data cable between the device and the Serial interface device. Follow the
procedure of web page configuration to set up parameters.
LED Indicators
SYS (Green):
P
ower indicator. When the power is on, the LED will be on and blink per second.
WiFi (Red):
WiFi indicator. When the WiFi is working, this LED will be blinking.
Tx (Green):
Data sending indicator. When data sending to the device from LAN or WiFi, this LED will blink.
Rx (Red):
Data received indicator. When data sending to the device from Serial ports, this LED will blink.