- 39 -
Level: 1
Carrier: 4.5
Asymmetry: 1.1
ProTools & Stryker 955 settings (SSB)
External Settings
Line-In & ProTools (Same as above)
ProTools session: Stryker SR 955HPC.ptf
Mbox 2 Mini
Button 1(left) output: at 3 o'clock
Mix: fully clockwise
Input 1: at 0dB marker
Input 2: N/A
Microphone In (Front panel microphone connector)
When using the microphone input at the front panel with a non-amplified dynamic
microphone (Rear Line-In connector unplugged):
Mic Gain: 1 o'clock position for SSB (Refer to the AM section above for AM settings)
Microphone: 600 Ohm, Dynamic
Note: Most hand microphones have a limited frequency response to 5000 Hz, which
greatly defeats the purpose of a Hi-Fi system. The EV RE20 is highly recommended. The
audio path here passes through the Stryker’s onboard microphone preamplifier, audio
high and low pass filters, ANL, ALC and tone circuits. Although these circuits have been
upgraded, factory design present certain bandwidth limitations. This input is intended
for use when audio processing is not available. Use this input as a last resource.
Internal Settings
SSB input audio level: 1.5 (This is the only blue pot in the center of the main board next
to the FM MOD control - pot W500)
Summary of Contents for IIIs
