Rubber Track Loader
5. Operator Enclosure Disassembly and Assembly
5-2
Figure 5-2
5-002
2.
Carefully lower the light bar with the wire har-
ness attached.
Figure 5-3
5-003
3.
View of light bar interior components. Interior
components are now accessible for servicing.
Figure 5-4
5-004
4.
View of dome light. If removal is required, simply
insert a lever (blade-type screw driver) at oppo-
site end of switch in pry-pocket, and gently pry
the light assembly out of the light bar.
Light Bar Installation
Figure 5-5
5-005
1.
Carefully position the light bar, without pinching
the wiring harness against the cab roof.
Figure 5-6
5-006
2.
Secure the light bar to the cab roof with the two
capscrews
Ignition Switch Removal and
Installation
The tools required for ignition switch removal and
installation are listed in Table 5-2. Use manufac-
turer-recommended tools whenever possible.
Table 5-2
Required Tools
Combination Wrench
Ignition Switch Removal
1.
Lower the light bar. Refer to
Chapter 5.
Light Bar
Removal
procedure.
